Selecting the Wide Stove Setting

Note:
Wide stoves are supported starting from firmware version v1.2.0. You can find out whether your Stove Guard supports wide stoves by checking the product packaging and/or the firmware version on the Sensor Unit or the Control Unit.

To change the Sensor Unit setting to Wide Stove, follow these instructions.

Note:
You can also easily change the settings from the Innohome EVO app. Download the app from AppStore or Google Play.

The following instructions are for changing the settings without using the app.

  1. Press and hold the sensor button until you hear two consecutive beeps. Release the button.
    The Sensor Unit confirms with a sound and light, and enters Setup Mode.
  2. Press and hold the sensor button until you hear two consecutive beeps. Release the button.
    The Sensor Unit confirms with a sound and light, and enters Stove Type Configuration Mode.
    Note:
    The Stove Type Configuration Mode is also used for Selecting the Wide Stove.
  3. Press the button 4 times to select the Wide Stove setting. When Wide Stove selected, there is no need to select the Stove Type separately, as all the Stove Types are supported automatically.
    When the Wide Stove has been selected, the Installation Zone must be set according to the settings table below.
    Note:
    The height settings are different than with the Normal Stove!

    1 press

    2 presses

    3 presses

    4 presses

    5 presses

    6 presses

    Zone 1

    (Cooker Hood)

    Zone 2

    (Cooker Hood)

    Zone 3

    (Cooker Hood)

    Zone 4

    (Wall)

    Zone 5

    (Wall)

    Zone 6

    (Ceiling)

    80 cm

    100 cm

    120 cm

    140 cm

    80 cm

    160 cm
    See the following figure for the different Installation Zone settings for a wide stove.