Mounting to Cooker Hood

The Sensor Unit is installed to the cooker hood with the flat installation bracket.

Note: The flat installation bracket can be installed with the adhesive tape on the back of the bracket or with two countersunk screws (3-4 mm thread diameter, not included in the sales package).

If you choose to install the bracket with the adhesive tape, make sure that the flat installation bracket is attached to the Sensor Unit before you begin.

If you choose to install the bracket with the screws, remove the bracket from the Sensor Unit before you begin.

  1. Find a spot for the Sensor Unit above the center point of the stove and clean the chosen spot thoroughly. See option A.

    For narrow stoves, such as compact two-burner cooktops, the Sensor Unit must not be installed directly above the center point. Instead, use an offset position of 15 cm to either side, as shown in Option B.

    Figure 1. OPTION A
    Figure 2. OPTION B
    Note: In cases where the cooker hood lamp gets hot, make sure that there is at least 10 cm of space between the installation bracket and the cooker hood lamp at the chosen spot.
    Note: If you chose to install the Sensor Unit with bracket with the adhesive tape, continue with the following instructions.
  2. Remove the protective film from the adhesive tape on the back of the flat installation bracket.
  3. Position the Sensor Unit so that the sensor button is facing down and it is on the right-hand side.
  4. Lift the Sensor Unit up to the chosen installation spot on the cooker hood.
  5. Firmly press and hold the Sensor Unit against the cooker hood for one minute to make sure that it is properly attached to the cooker hood.
  6. Measure the distance from the cooktop to the cooker hood.
    Change the settings in Innohome EVO App regarding the installation height, stove width and stove type. Or follow the instructions for the one-button interface: for narrow stoves (typically 30 cm wide) and standard cooktops (typically 60 cm wide), see Changing the installation zone.

    For stoves wider than 60 cm (typically 80-90 cm wide), see Selecting the wide stove setting.