Fixed Installation (C320-TITO-INN)

  1. Switch off the power from the electrical panel.
  2. Remove the Control Unit lids and the strain relief (Option A).
    Remove the Control Unit lids (Option B).
    Option A


    Option B
  3. Remove the knock-out lids (Option A).
    Remove the knock-out from the bottom (Option B).
    Option A
    Option B
  4. Connect the wires as shown in the images below, in 1, 2, or 3 phases.
    Note:

    The middle wire (the terminals marked L3) must always be connected for the Control Unit to start.

    Note:
    Do not overtighten the screws.

    Option A

    Figure 1. 3-Phase wiring
    Figure 2. 2-Phase wiring
    Figure 3. 1-Phase wiring

    Option B

  5. Attach the strain relief.
    Option A
    Option B
  6. Close the Control Unit lids.
    Option A
    Option B
  7. Remove the protective film from the adhesive tape and firmly press and hold the unit against the wall for one minute to make sure that it is properly attached to the wall.
    Note:
    Optionally, you can attach the unit to a wall with four M4 screws.


  8. Connect the stove power plug.
    Make sure that the plug is properly plugged all the way.
  9. Switch on the power to the stove from the electrical panel.