Plug & Play (C320-PIPO-INN)

  1. Switch off the power from the electrical panel.
    DANGER: Do not turn on the power from the electrical panel until the Sensor Unit and the Control Unit are set and ready for a function test!
  2. Remove the stove plug from the stove wall socket.
  3. Connect the stove plug to the Control Unit and the Control Unit to the stove wall socket.
  4. Remove the protective film from the adhesive tape and press the unit against the wall. Press firmly for one minute to make sure that the unit is properly attached.
    Note: Optionally, you can attach the unit to a wall with four M4 screws.
  5. Connect the stove power plug.
    Make sure that the plug is properly plugged all the way.
  6. Switch on the power to the stove from the electrical panel.